Laser Engraving a Microfiber Pillow

One of our customers' favorites things about working with our equipment is experimenting with different materials to find new and exciting items to expand their product line and profit potential.

Here we engraved a stunning design on two micro-fiber throw pillows. It creates a subtle, yet sophisticated engraving that makes any space warm and inviting.

今すぐダウンロード

必要な道具

Microfiber Throw Pillow
Epilog Laserシステム

We used a 45-watt Helix with the following settings: 100% speed, 20% power, Center-Center Engraving.

NOTE: Pillow surfaces can be challenging because they are not always flat. If you can find throw pillows with zippered covers, it would simplify this process. Additionally, you could unstitch one corner of a pillow, remove the stuffing, engrave accordingly and then reassemble.

red dot pointer at the center of the pillow

Due to the nature of the material and shape of the pillow, we want to ensure our graphic ends up in the correct place.

To do this, draw a vector box around the graphic. Make sure the thickness of the line is set to "Hairline."
Move the engraving table down and place the pillow inside the machine.
Turn on the Red Dot Pointer.
Disable your x/y axis and move the home position to the center of the pillow.
When the dot is centered, set your new home position.
Send the vector job the engraver. Make sure to run the job with the lid open.

When you are satisfied with the placement of the box, it's time to focus the machine.

Attach the manual focus gauge.
Disable the x/y axis.
With your hand, move the focus gauge to the four corners of the area in which your graphic will appear to make sure that all four corners are at an approximately equal height.
Because the surface may not be entirely flat, we suggest manually focusing the machine between the highest and lowest points on the square . In other words, if your top-left corner is higher than your bottom left, manually focus the machine between those two points.
When you are finished, if you feel you would like your engraving to go deeper, do not move the pillow from the engraving machine. Simply press go to repeat the job.